ELECTRODE This FlumeAir™ Flame Sensor and Ignitor is required for use with the R44992001 Electrode to create a complete ignition module. The Flame Sensor and Ignitor is designed to be in a heated gas or air stream at all times, continuously sensing flame detection. The Flame Sensor is designed for Armstong FlumeAir™ R44992001 Electrode supplied and used in conjunction with the electrode reference number, found on the face plate. 3 year parts & labour warranty Fitted with flame control sensor and ingniter, Flame rod at end of each tube. Safe electrically designed to prevent gas bottle venting when flame fails DESCRIPTION AND USAGE: Flame Sensor and Ignitor are designed to replace ignitors on Water Heater & Gas appliances. It is a MODIFIED MAKE AND MODEL REPLACEMENT. WARNING: This Product can expose you to chemicals including Nickel, which is known to the State of California to cause cancer. For more information go to www.p65warnings.ca.gov This ignition module is for use on Gas furnace with C60* Series blower motor assembly. The electrode is used in a similar fashion to a spark plug, except that it relies on thermal Flame Sensor and Ignitor This Flame Sensor and Ignitor is used on Armstrong/Rheem gas heaters manufactured prior to 1998 and into the year 2000. It is also used on some Honeywell gas heaters manufactured prior to the year 2000. It fits all models of these brands with 3-Pole (4 wire) heaters. Replacing your electrode will help to eliminate pilot lights shutting off or clicking, pilot lights relighting after being turned off, pilot relamping, burner noise,