These are incredibly frustrating situations for most people: Opening the door of your beloved vehicles only find the musty scent of a wet interior hitting your nose. Or perhaps sitting down in the driver’s seat only find yourself surrounded by all kinds of noises. The constant closing and opening of doors, and rolling up and down of windows for years, the original weather seals gradually getting useless, loosening, and even peel off from its places, which makes cold/hot air and moisture to get inside with ease. To improve these terrible situations, we specialize in providing this door weatherstripping, it is made from ozone resistant EPDM rubber and designed to seals the edges of your vehicle’s doors, windows, windshield, and other areas which protect the doors and the vehicle from corrosion. The weatherstrip creates a tight seal that eliminates rattles, wind noise, and water damage.
Features:
- 100% brand new and high quality.
- Package with 10 custom-cut seal strip. Including the front/rear door, Front Pillar(A Pillar) and Center Pillar(B Pillar), Hood and Trunk strip, Easily install with instructions.
- The weather stripping are mainly used to seal the gap between car door, hood, trunk, window and door frame etc.
- Made of EPDM expandable hollow sponge rubber. Rugged and durable, and good resistance to heat & cold. Has a sealing, waterproof, lower voices, the role of dust.
- The Car Door Rubber Seal Strip has been custom-cut specifically . Measured and tested countless times on the vehicle to reduce wind noise from entering the cabin along with other outside noises.
- Enhance the tightness of the door, Sound insulation, and noise reduction, optimizing engine compartment cooling airflow, Improve the cooling effect of the air conditioner in the cab, reducing driving wind noise. And provide a quiet driving environment.
- Easy to install: Clean the door edge. Wiped adhesion promoter on the surface. Pull off the sticker red protective backing of the seal. Hard press to ensure it can be installed firmly
Why should I use this Door Seal Kit?
2 x Front Door Strip
2 x Rear Door Strip
2 x A Pillar Strip
2 x B Pillar Strip
1 x Hood Strip
1 x Trunk Strip
Instructions:
Step 1: Clean your model 3 door edge
Step 2：Wiped adhesion promoter on the installation position;
Step 3: Direct replacement tape, you just need to push the stripping foam on the rubber sealant above the installed place.
If you need Installation Video, please click the following link:
https://www.youtube.com/watch?v=G4eFTl-B1Cc
