H13 Error Fixer / CANBUS Decoder – For LED & HID Conversion Kits
Prevents Flickering, Flashing, and Warning Errors

Product Description

If you’ve installed an HID or LED kit and experience flickering, flashing, or lights not staying on, your vehicle likely has a CANBUS system that monitors bulb sockets and detects a mismatch. HID and LED bulbs draw less power than halogen bulbs, triggering error messages. This error fixer resolves that issue by simulating the correct load.

Specifications & Features

• Type: H13 Plug & Play Error Canceller / Decoder / Warning Fix

• Function: Eliminates OBC warning errors, bulb-out indications, and excessive flashing

• Compatibility: Works with any HID or LED conversion kit using H13 connectors

• Connector Type: H13 male and female – plugs between vehicle wiring and kit wiring

• Load Resistor: 50W, 6 Ohm

• Voltage Range: ~10V–15V

• Installation: Easy pre-wired, plug & play – no cutting required

• Capacitor Module: Attached; may be cut off if not needed for your vehicle

Vehicle Compatibility

Package Includes

• 2 x H13 Type Error Fixer / Decoder (Pair)

Important Installation Notes

• These units contain resistors and can get HOT.

  • Mount on a metal surface or in open air – do not mount on plastic that could melt.

  • Avoid touching during or immediately after operation.

• If your vehicle does not require the attached capacitor module, it may be safely cut off.

• Professional installation is recommended if you are unsure of the wiring process.

Note: If you have any questions about compatibility or installation, please contact us before purchasing.