High Quality 12v Rocker Switches single throw ON/OFF, designed to operate all of your 12V accessories, these switches have a surface of 2”(50 mm) x 1”(25 mm) and use a standard din size mounting hole of 1.41”(36 mm) x .86”(22 mm), standard size measurements for all the switch wholes in most modern vehicles; however, some of them might be a little narrower than others, especially late model vehicles. So we recommend you to check the size of the hole in your vehicle.

• Single Pole Single Throw ON-OFF switch.

• Black hard surface rocker.

• Two LEDs in the switch.

• Upper LED is ON only when the switch is turned ON.

• Lower LED is independent.

• Both LEDs have separate grounds.

• Same size as the Carling and ARB switches.

• Rated 16A 12V.

• No rear barriers between terminals.

• Wiring diagram supplied with switch.

All symbols are laser etched directly onto the switch face to ensure long image life. We do not use stickers or ink which will wear off in a very short time.

You can install our switches in your Jeep JK by purchasing on of this switch pods especially designed for your vehicles right in our store @

http://www.ebay.com/itm/Daystar-A-PILLAR-SWITCH-POD-2007-2010-Jeep-JK-/201064336241

http://www.ebay.com/itm/Daystar-Jeep-Wrangler-JK-11-13-Switch-Panel-FOR-AUTOMATICS-ONLY-/201064332991

http://www.ebay.com/itm/Rugged-Ridge-A-Pillar-Switch-Pod-For-11-14-Jeep-Wrangler-JK-/191173149229