HOW TO USE
How to Use
1.Select the Correct Extractor，Too small = slipping; too large = won’t fit.
2.Pre-Drill (If Head Is Severely Damaged)
Use a left-hand drill bit or center punch to create a pilot hole.This helps the extractor bite into the metal.
3.Install the Extractor
Securely mount the extractor to the appropriate adapter or tool.
4.Extract the Fastener
Engage in reverse (counter-clockwise) direction only.
Apply steady, controlled torque—do not run at high speed.use constant pressure in reverse (slow speed) to drive in the extractor until it bites
5. Slow rotation
Slow keep turning the screw/bolt/plug out until it works free
6. Use hand tools only, or operate at a low speed when using a power tool.
NOTE: drill bit and socket adapter are not included.
