brand new and high quality
Material: Plastic and Alloy
Color:
See pictures
See pictures
These for touch plates make setting your tool height and zeroing your
Z-axis a breeze. These are fully functional in Mach 3 and many other
controller software. Overall diameter is 1-3/8".
Cord is approximately 4ft. long. Cord is attached to plate on one
Wire and has an alligator clip on the other to ground the spindle/router and compete the circuit.
Other end of wire is ready to be wired as a for touch probe into your electronics.
Connect the wire of this tool check insturment to the tool connector of your Control board of the machine, then the control
Diameter: 3.5 for cm/1.38"
Effective surface diameter： 25mm/0.98"
Thickness: 2 for cm/0.79"
Cable length: 110 for cm/43.3"
Quantity: 1Pc
Note: Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!