About this vehicle

*This truck has a 6.0 (LQ4) and 4L80e swap! It will not pass CA smog because it has shorty headers, a cold air intake and aftermarket catalytic converters.* There are no issues with this truck. No leaks and no check engine light. The heater works, and it has cold AC. I am selling this because I want to finish my OBS single cab project. I purchased this 2000 Silverado in October of 2021 with 215,934 on the truck. The previous owner installed new wheels and tires and a 2003 Silverado front clip. As of now (05/25/2026), the truck has 228,687 which means I have put 12,631 miles on it since January 2022 (approximately 3,000 miles per year). I have a clean Texas title in-hand. I have all the parts and labor receipts (digital & physical), too. . The bad things about the truck are someone keyed the driver side, the cruise control doesn’t work, the paint is a 7 out of 10, and the emergency brake needs to be adjusted. . The truck was with my mechanic in Texas from October 2021 through December 2021 getting all the major mechanical issues addressed and adding performance/appearance goodies, too, and then again in March 2025 through July 2025 getting a 6.0 (LQ4) and 4L80E swap. I can provide receipts and pics. . Here is a list of all the parts and labor I have done to this truck since I purchased it in October 2021. . . Engine: 6.0 swap (LQ4) and fully resealed ASP Under drive pulley Volant Cold Air Intake Shorty Headers New OEM style exhaust dumped into a single 3 40 series Flowmaster Two new catalytic converters FAST Ignition Coils MSD Plug wires NGK spark plugs TBSS Intake manifold 92mm throttle body Electric fans with adjustable thermostat & wired to A/C New valve cover gaskets New thermostat and housing New Heater Hose K&N fuel filter New dipstick tube ECM tune for 6.0/4L8OE swap New starter New A/C compressor New water pump Various sensors replaced ICT Billet knock sensor relocation kit . . Transmission: 4L80E swap Transmission flush and filter New transmission mount Custom built transmission crossmember Mishimoto Tranny cooler New Driveshaft support bearing . . Rear end: Fluid exchange New u-joint, straps, and bolts . . Wheels & Tires: 285/45/22 Kumho Crugen HP71 Niche M231 22x10.5 (Snowflakes) Full-size spare and jack . . Brakes: Power Stop K2010 cross drilled & slotted rotors Evolution Sport Carbon Fiber/Ceramic pads Braided Stainless steel brake lines . . Front Suspension: TRQ upper and lower A-arms w/ new ball joints New outer tie rods New inner tie rods New rack & pinion assembly Monroe Matic Plus Shocks MaxTrac 2” lowering spindles DRIVERSTAR Hub & bearing assembly Alignment after all work was done New power steering pump, hoses, and reservoir Energy Suspension sway bar end links . . Rear Suspension: 6” flip kit with McGaughy’s bolt-on c-notch Belltech 8510 Nitro Drop 2” shocks Belltech 6654 shock extension kit Frame-mounted hidden hitch Flip-down license plate frame . . Exterior: 2003 taillights LED taillights & LED 3rd brake light (included) LED reverse, license plate, cargo light, & turn signals LED low beam & high beam Herculiner bed liner Mounted lower valance with nylon lock nuts 03-06 HD hood 03-06 Silverado HD front clip 20% tint New windshield wipers New tailgate latches New tailgate cables Slow-drop tailgate strut Stake pocket covers Tailgate lock Interior: LED interior lights Replaced various missing pieces Black suede headliner Power locks Power windows Car alarm 7” Soundstream VRCPAA-70M head unit w/ Carplay & Android Auto Backup camera Kicker amp 10” Rockford Fosgate P3 sub Skar speakers throughout Smartliner catch-all floor mats   Please let me know if you have any questions.  Thanks!

Vehicle Details

*This truck has a 6.0 (LQ4) and 4L80e swap! It will not pass CA smog because it has shorty headers, a cold air intake and aftermarket catalytic converters.*

There are no issues with this truck. No leaks and no check engine light. The heater works, and it has cold AC. I am selling this because I want to finish my OBS single cab project.

I purchased this 2000 Silverado in October of 2021 with 215,934 on the truck. The previous owner installed new wheels and tires and a 2003 Silverado front clip. As of now (05/25/2026), the truck has 228,687 which means I have put 12,631 miles on it since January 2022 (approximately 3,000 miles per year). I have a clean Texas title in-hand. I have all the parts and labor receipts (digital & physical), too.

.

The bad things about the truck are someone keyed the driver side, the cruise control doesn’t work, the paint is a 7 out of 10, and the emergency brake needs to be adjusted.

.

The truck was with my mechanic in Texas from October 2021 through December 2021 getting all the major mechanical issues addressed and adding performance/appearance goodies, too, and then again in March 2025 through July 2025 getting a 6.0 (LQ4) and 4L80E swap. I can provide receipts and pics.

.

Here is a list of all the parts and labor I have done to this truck since I purchased it in October 2021.

.

.

Engine:

6.0 swap (LQ4) and fully resealed

ASP Under drive pulley

Volant Cold Air Intake

Shorty Headers

New OEM style exhaust dumped into a single 3 40 series Flowmaster

Two new catalytic converters

FAST Ignition Coils

MSD Plug wires

NGK spark plugs

TBSS Intake manifold

92mm throttle body

Electric fans with adjustable thermostat & wired to A/C

New valve cover gaskets

New thermostat and housing

New Heater Hose

K&N fuel filter

New dipstick tube

ECM tune for 6.0/4L8OE swap

New starter

New A/C compressor

New water pump

Various sensors replaced

ICT Billet knock sensor relocation kit

.

.

Transmission:

4L80E swap

Transmission flush and filter

New transmission mount

Custom built transmission crossmember

Mishimoto Tranny cooler

New Driveshaft support bearing

.

.

Rear end:

Fluid exchange

New u-joint, straps, and bolts

.

.

Wheels & Tires:

285/45/22 Kumho Crugen HP71

Niche M231 22x10.5 (Snowflakes)

Full-size spare and jack

.

.

Brakes:

Power Stop K2010 cross drilled & slotted rotors

Evolution Sport Carbon Fiber/Ceramic pads

Braided Stainless steel brake lines

.

.

Front Suspension:

TRQ upper and lower A-arms w/ new ball joints

New outer tie rods

New inner tie rods

New rack & pinion assembly

Monroe Matic Plus Shocks

MaxTrac 2” lowering spindles

DRIVERSTAR Hub & bearing assembly

Alignment after all work was done

New power steering pump, hoses, and reservoir

Energy Suspension sway bar end links

.

.

Rear Suspension:

6” flip kit with McGaughy’s bolt-on c-notch

Belltech 8510 Nitro Drop 2” shocks

Belltech 6654 shock extension kit

Frame-mounted hidden hitch

Flip-down license plate frame

.

.

Exterior:

2003 taillights

LED taillights & LED 3rd brake light (included)

LED reverse, license plate, cargo light, & turn signals

LED low beam & high beam

Herculiner bed liner

Mounted lower valance with nylon lock nuts

03-06 HD hood

03-06 Silverado HD front clip

20% tint

New windshield wipers

New tailgate latches

New tailgate cables

Slow-drop tailgate strut

Stake pocket covers

Tailgate lock

Interior:

LED interior lights

Replaced various missing pieces

Black suede headliner

Power locks

Power windows

Car alarm

7” Soundstream VRCPAA-70M head unit w/ Carplay & Android Auto

Backup camera

Kicker amp

10” Rockford Fosgate P3 sub

Skar speakers throughout

Smartliner catch-all floor mats

Please let me know if you have any questions.  Thanks!

Exterior

Interior

Engine