Package List
1x Hand held vacuum pump tester
1x Storage jar
7x Adapters
1x Cup adapter
4x Vacuum hoses (2PCS 4"L, 2PCS 20"L)
2x Plastic covers
1x Instruction
1x Blue case

Wide Usage
Computerized engine control devices
Ignition control devices
Brake systems
Systems testing: AC & heating controls, cruise control systems, headlight cover doors, fuel tank & line testing, vacuum door lock systems
Seal reusable vacuum food storage bags

Easy to Bleed the Brake Oil
1. Make sure vehicles master cylinder reservoir is full
2. Bleed the system in the following order:
a. Master cylinder (If bleeder equipped)
b. Wheel cylinders and calipers in succession, beginning with the wheel closest to the master cylinder and progressing to the one farthest from it
3. Assemble the brake clutch fluid bleeder tool according to following sequence: Hand pump - 4" hose - transfer cover "To Pump" side - 4" hose to the bottom of the transfer cover & storage jar - 20" hose - proper size adapter - vehicle brake bleeder valve
4. Attach the brake bleeding fitting to the bleed screw and pump the brake bleeder pump 10-15 times to create a vacuum in the storage jar
5. Open the vehicle’s brake bleeding fitting 1/4-1/2 turn and allow about 2 in of fluid to flow into the storage jar
6. Fill the master cylinder reservoir back to normal with fresh fluid and proceed to the vehicle’s next brake and perform the same steps as above

3.When removing the interior panel, decorative strip and other large objects, two tools of similar size can accomplish the task more quickly and with less effort.
This multi-functional vacuum pump kit can be widely used to test a variety of essential vehicle settings and operations, such as Computerized Engine Control Devices, Ignition Control Devices, Air Condition & Heating Controls, Cruise Control Systems, Brake Systems etc., especially work for changing brake clutch fluid and power steering fluid. Use the hand pump to form negative pressure in the brake system, sucks out waste oil and air, and guide the new oil to fill all the system.
The included three differently sized black L type rubber connectors and two straight cone rubber connectors, can connect with the brake bleeder valve on any vehicles or motorcycles that use standard brake bleed valves. Use the closest sized one to ensure a tight fit. And bleed from master cylinder to wheel cylinder and caliper. There is a universal cup adapter packed in the case, can use as a vacuum sealer to match with your reusable vacuum food storage bags.
The hand pump adopts brass cylinder with a -30 to 0inHg gauge, has pressure-maintaining function and a pressure relief valve on the cylinder. The tool also uses rubber trigger cover to protect hand. The 2PCS 20"L and 2PCS 4"L transport hoses are transparent, help to observe if the waste oil is all pumped out. When you see the clear new brake oil is sucked out in the hose without any air bubble, then done.
In the hand held vacuum pump tester set, there is a 120ml / 4.5oz storage jar, which has liquid storage cover and liquid transfer cover with 2PCS O-rings for sealing. Please note, there is a connection direction request for the liquid transfer cover, connect the side marked "TO PUMP" to hand pump by short 4"L hose, if not, the waste oil may be sucked into the pump and destroy it. Do not invert the jar while using too.
If after pumping several times and you can not pump any more, but the index keeps on certain readings without dropping, maybe it is because of a blocked brake bleeder valve. You need to clean the brake bleeder valve first, and then do not forget to suck out the air if you do not change the waste oil this time.