👮‍♀️🍩🚔 Fraud alert- we video these at the postal service counter while the clerk encloses them and scans the shipping label

❌🛑⚠️DO NOT BUY from us if you are a

TRANSMISSION shop, Car dealership or Automotive Repair Shop

❌🖐️🛑Not A DIY RESET ADAPTATIONS USING BMW SOFTWARE INPA OR ISTA IS A MUST, OR YOU WON'T SEE ANY DIFFERENCE AFTER REBUILT, BECAUSE TCM KNOWS VALVE BODY PRESSURE VALUES AND THEY MUST BE RESET.

PLEASE NOTE:

Must be reflashed with J2534 re-flashing platform to your ECM

Programming a replaced Transmission Control Module (TCM) typically involves several steps, which can vary depending on the make and model of your vehicle. Here’s a general guide:

1. Gather Required Tools and Equipment

* OBD-II Scanner/Programmer: Make sure to have a compatible OBD-II scanner that can program TCMs.

* Vehicle Service Manual: This will provide specific instructions and details for your vehicle.

* Battery Charger: To maintain battery voltage during programming.

2. Prepare the Vehicle

* Disconnect the Battery: To prevent any electrical shorts, disconnect the negative terminal of the battery.

* Remove Old TCM: If not already done, remove the old TCM according to your vehicle's service manual.

3. Install the New TCM

* Connect the New TCM: Install the new TCM and ensure all connectors are securely attached.

* Reconnect the Battery: Reconnect the negative terminal of the battery.

4. Programming the TCM

* Turn on the Ignition: Without starting the engine, turn the ignition to the "On" position.

* Connect the OBD-II Scanner: Plug your OBD-II scanner into the vehicle's diagnostic port.

* Access TCM Programming Function: Navigate to the TCM programming section in the scanner's menu. This may be labeled as “TCM Programming,” “Module Programming,” or similar.

* Follow On-Screen Instructions: Follow the prompts on your scanner to program the new TCM. This may include inputting vehicle specifications or VIN.

* Calibrate the TCM: After programming, you may need to perform a calibration procedure. This is often necessary for the TCM to learn the vehicle's parameters.

5. Test the System

* Start the Engine: After programming, start the engine and allow it to idle for a few minutes.

* Check for Error Codes: Use the OBD-II scanner to check for any error codes. Clear any codes if necessary.

* Test Drive: Take the vehicle for a test drive to ensure the transmission is functioning properly.

6. Final Steps

* Recheck Connections: After testing, recheck all connections and ensure everything is secure.

* Perform Additional Diagnostics: If any issues arise, further diagnostics may be required.

Notes

* Consult Professionals: If you are not comfortable with programming the TCM yourself, consider taking the vehicle to a professional mechanic or dealership.

* Vehicle-Specific Procedures: Always refer to the vehicle's service manual for specific programming instructions, as procedures can vary widely between different manufacturers and models.

By following these steps, you should be able to successfully program your replaced transmission control module.

☝️This is a Genuine OEM Engine ECM Control Module for vehicles from brands like ECM, designed for use in models such as ENCLAVE, CTS, CAMARO, ALLURE, and ACADIA. The Interchange Part Number is 590-01766, Part Number is 590, and Stock # is GCC552. This module is compatible with vehicles from the years 2010-2011.