FPU1 FTDI USB JTAG programmer is designed for programming XILINX FPGA/CPLD/FLASH ICs. It is also can be used for programming other JTAG devices. It is easy to use, has small sizes, and supports wide range of Vref JTAG chain voltages. Guide for this programmer includes step by step instructions for programming XILINX devices.

Features

· FTDI FT2232 USB controller

· Buffered port for programming JTAG devices. Vref 1.65V - 5.5V

· Programmer is powered by 5V from USB

· 2.54mm pitch 6 pin JTAG header

· Small 25 x 25(mm) PCB outline

· With included cable and adapter, it can be connected to any 2.54mm pitch connector and to 2mm pitch 14pin XILINX standard connector 

Instructions

FPU1 FTDI USB JTAG programmer has FTDI FT2232 USB controller onboard. PORT A of FT2232 is configured as JTAG interface. It is connected to buffer IC’s. They are needed to amplify driving current and to widen the supported voltage levels. Buffer IC’s are connected to 6 pin JTAG header J2, with 2.54mm pitch. Programmer is powered by 5v from USB, but still, external Vref JTAG voltage must be connected. Vref voltage must match JTAG signals voltage. Programmer can work with Vref from 1.65v to 5.5v. This includes 1.8v, 2.5v, 3.3v and 5v standard signal levels. As long as you can find right software, you can program any JTAG device with this programmer.

Package includes programmer, cable, and adapter for 14 pin connector. Programmer has USB connector on one side, and 6-pin male header on the other side. Cable has 6-pin, 2.54mm pitch, female connector on one side, and separate 1-pin, 2.54mm pitch, female connectors, for every wire, on the other side. Adapter has 6-pin, 2.54mm pitch, male header on one side, and 14-pin, 2mm pitch, female connector on the other side. JTAG signal locations are marked on the PCB.