Genuine Original Hunter Replacement Remote Control #99119
For Hunter Ceiling Fans
This is a direct replacement for remote # 99119 ONLY
Wall Bracket/Cradle not included
Wireless receiver not included
NOTE: This is NOT compatible with older versions like #27185 that have dip-swicthes
Requires 3V CR2032 Battery (included)
Part #K0471-01
FCC ID: IN2TX43
FREQ: 434 MHz
Part #K0471 must match for compatibility. Please inquire if you're not sure.
Pairing Instructions (The remote must be paired before the fan will operate.)
- Turn OFF power at the breaker for at least 30 seconds
- Turn ON power at the breaker
- Within 3 minutes of restoring power to the fan, press both the Fan Off button and the High button for at least 4 seconds. Your fan will turn on low to indicate successful syncing. If it does not, turn off power to your fan, wait 1 minute then try again. If using the transmitter with multiple fans, repeat this process for each fan.
- IMPORTANT: Use the pull-chain switch on the fan to set the fan speed to the HIGH position before operation.
