Features

1.This injector Height Gauge Kit is for Detroit Series 50 and Series 60 engines. Used to properly set injector body height to the injector follower for proper fuel injector timing.

?

2.Includes 78.2mm, 78.8mm, 80.3mm, 81.0mm and 82.1mm gauge blocks along with knurled handle that allows for block to be used at 90° angle for use in areas with restricted access.

?

3.Similar to J-42749, J-45002, J-39697, J-42665, J-35637-A.

?

4.Machined from high quality steel, providing enough strength and durability, corrosion-resistant, anti-wear property, solid and sturdy, no deformation.

?

5.If you're not 100% satisfied with our item, simply return it for a full refund in 30 days, no questions asked money back guarantee with 12 months’ warranty.

?

Product Description

A must have tool set for proper fuel injector timing!

Function

(Incorrect injector timing can cause engine power issues, poor idle quality and fuel mileage issues.) 

Our injector height gauges are used to properly set injector body height to the injector follower for proper fuel injector timing.

Note: Be sure the height gage seats on the machined surface with the tip in the pilot hole. Adjust the height until you can slide over it and find that slight drag.

Applications

78.2mm, Series: 60, Engine: DDEC I, Year: 1986-1993

78.2mm, Series: 60 and 50, Engine: DDEC II, Year: 1986-1993

78.8mm, Series: 60 and 50, Engine: DDEC III, Year: 1994-1997

80.3mm, Series: 60, Engine: DDEC III, Year: Late 1997

80.3mm, Series: 60 and 50, Engine: DDEC IV, Year: 1997-1998

81.0mm, Series: 60 and 50, Engine: DDEC IV, Year: 1998-1999

81.0mm, Series: 60, Engine: Marine, Year: 2000-2003

82.1mm, Series: 60

Package included

?
The kit comes with 5 measuring blocks in sizes:

78.2mm, 78.8mm, 80.3mm, 81.0mm and 82.1mm along with knurled handle