FCC ID: ELGTX7

 Part #: 26671

 Frequency: 315 MHz

 LED color: Green/Red

 5 buttons

 Compatible with the following systems:

AutoCommand  models

26024,26027, 26028, 26036, 26038, 26727, and 20029;

Ready Remote model

26727

 Ready Start model

24739T

 Programming Instructions:

Your system can learn up to 4 transmitters. The following procedure will show you how to add additional transmitters or replace old ones. The remotes in this package have already been programmed to the control module.

Each transmitter can be programmed one button at a time or you can use an auto learn procedure that learns the intended factory configuration. Learning one button at a time is generally only used when using one transmitter to control two different cars. Being able to program functions to different channels on each transmitters prevents multiple cars from responding simultaneously.

1. Turn the ignition ON
2. Press/release the Momentary switch the same number of times as the desired transmitter learn step number, and then Press/HOLD.
3. After holding the Momentary switch for 2 seconds the LED will begin to flash to indicate the number of the accessed transmitter learn step.
4. Press the transmitter button that you want to control the function assigned to that channel. The Horn/Siren will emit a long chirp.

NOTE: For transmitter learn Step #1, you must press the “*” button on the transmitter. This will automatically program the transmitter buttons to the default function configuration. See the transmitter button auto learn chart for the assignment functions.

You can learn more than one transmitter function without having to repeat the entire procedure by advancing to the next channel immediately after programming your first channel.

To do this, first release the Momentary switch and then press/release it the same number of times as the difference between the current transmitter learn Step and the desired transmitter learn Step, and then press/HOLD it.

Example:

To advance from Transmitter Learn Step 2 to Transmitter Learn Step 8, release the

Momentary switch and then press/release it 6 times and HOLD it on the 7th press.

After holding the Valet switch for 2 seconds the LED will flash 8 times and repeat. You can now learn a transmitter button to step 8.

There are several ways to exit Transmitter Learning, by TimeOut, Ignition or Momentary switch presses.

1. TimeOut: If more than 15 seconds elapse between Momentary switch presses or transmitter signals.
2. Ignition: If the Ignition is turned off at any time during transmitter Learning.
3. Momentary switch presses: if you press/release the Momentary switch more times than there are Transmitter Learning steps in the menu.

The Horn output will pulse 5 times rapidly and the LED will turn off to indicate that you are exiting feature programming.