Pre-wired 5 Pin SPST Rocker Switches
Nilight 3 Gang rocker switch aluminum panel with DIY stickers, can customize these switches as your demands to remind you while using. With pre-wired wiring harness for you to easily install in both 12V and 24V vehicle, yacht, ship, caravan, truck, etc.
- Panel Size:Length x Width x High(3.8''x2.6''x3.4'')
- Installation: Pre-wired
- Material :Aluminum panel, Switch:ABS+PC
- Style:SPST (Single Pole Single Throw) On/Off
- 3 gang rocker switch aluminum panel with DIY sign stickers can customize these switches as your demands to remind you while using With pre-wired wiring harness for you to easily install in both 12 volt and 24 volt vehicle yacht ship caravan truck etc.
- Safe and durable, built with fuses easy replace and can protect the panel from over-heating, over-current overcharging and short circuit
- Panel size: The aluminum panel dimension length x width x high (3.8''x2.6''x3.4''); Cutout dimensions (2.9''x1.5''x3.5'')
- Quality assurance made of strengthened aluminum panel and well-conductive pins ensure long lasting durability highly optimized for general use and will give you a pleasant experience
- The package includes 1x 3 gang switch panel, 1x screw sets 1 set of DIY stickers
Durable Components
Made of ABS and PC of premium quality, the switch is impact and heat resistant and it's flexible for turning on or off. prolonging the device life.
- Input voltage: 12V/24V DC
- Amp rating for each switch: 12V DC/20AMP; 24V DC/10AMP
- Switch Terminal: 5 PIN
Durable In Use
The switch is very flexible for turning on or off. It can stand up to 10,000 times pressing under normal use.
Pre-wired wiring harness
Rocker switch panel with pre-wired wiring harness for you to easily install in both 12V and 24V vehicle, yacht, ship, caravan, truck, etc.
Night Glow DIY Sticker
Coming with 132PCS night glow stickers with various patterns and words, which meets your DIY needs and help you find the switch in the dark easily.
Easy Disconnection
The wiring harness on the switch can be easily disconnected by pressing down the clips.
Premium Jumper Wires
The jumper wires are made of high quality 14 gauge wires. The Tin-plated copper terminals on the wire are of good stability, wear resistance.
Backup Lights
The lower LED illuminates constantly even when the switch is OFF, easy to find in the dark.
No Backup Lights
The lower LED will illuminate only when the switch is turned to ON position.
Wide Application
Suitable for most DC 12V-24V cars, UTV/ATV, trucks, trailer, RV, caravan, bus, marine boat, yacht, airplane, etc.
Use on Marine Boat
Marine-grade Construction and IP65 Waterproof.
best for marine but submerged in water operation is not recommended.
Car Electronic Device
suitable for UTVs and ATVs.
Installation is simple and can be mounted horizontally or vertically. You can even use it at -25°(Min) or 80°(max).
Use on UTVs
It's dimension is the same as the original factory switch on UTV vehicle, which can replace damaged UTV switches without the need for drilling holes.
